-40%
Serape HTV Iron On Vinyl Siser Heat Transfer Vinyl - Transfer Tape Provided 11C
$ 2.93
- Description
- Size Guide
Description
Professionally printed pattern vinyl Iron On heat transfer vinyl HTVTons of patterns & options! Contact us if you'd like to make a special request or custom pattern!
Spend or more and get Free Shipping on us!
High-quality pattern vinyl
Patterned Iron On Heat Transfer Vinyl HTV
Bundle discounts available!
Cut out any shape or design & apply!
Take advantage of our huge selection of patterns & colors!
Please be sure to check out the easy application instructions below!
All you need is a plotter or cutter!
All Patterns are printed with a large format Roland printer that uses Eco-solvent genuine inks.
Iron on Heat Transfer Vinyl - For Any Garment or Fabric
Printed on Siser ColorPrint Easy (TTD High-Tack Mask Provided)
Heat Transfer is printed without the carrier. Siser TTD Easy Mask is provided
for application
Cut on Pattern Side and DO NOT MIRROR. After weeding excess vinyl, apply
TTD Easy Mask to transfer design off of the backing and place on your garment face up
Can be applied with a home iron and/or heat press
CUTTER SETTINGS
Cricut:
Blade: Standard
Setting: Iron On
Silhouette Cameo:
Blade: Standard, 3
Material: Heat Transfer, Smooth
Speed: 8
Force: 6
Scan N Cut:
Blade: Standard, 2
Cut Speed: 1
Cut Pressure: 1
Roland GS/GX-24:
Blade: 45°
Gram Force: 80-90
Offset: 250
Speed: 25-50 cm/s
Graphtec:
Blade: 45°
Gram Force: 9
Tool: CB09U+0
Speed: 25 cm/s
MH, SC2, LP3, & Titan 1:
Blade: 45°/60°
Gram Force: 80-85
Speed: 300mm/s
*Blade Advancing Varies
Titan 2 & 3
Blade: 45°/60°
Gram Force: 60-65
Speed: 300mm/s
*Blade Advancing Varies
Settings may vary based on blade condition and age of machine.
Always perform a test cut prior to cutting designs.
APPLICATION INSTRUCTIONS
Application Instructions (home iron)
Set iron dial between Cotton and Linen
Cover design with Kraft paper or non-stick cover sheet
Place on flat, hard surface (ironing board not recommended)
Press iron with medium/firm pressure (do not slide iron)
Press each section of design for 15 seconds
If areas of design lift after application, replace cover sheet
and re-press for 10 seconds
Peel carrier hot or cold
Application Instructions (heat press)
Cut material - don't mirror!
Weed excess material
Mask with TTD High Tack Mask
Preheat garment for 2-3 seconds
Apply design at 305°F/150°C
Use medium pressure for 10-15 seconds
Peel carrier hot or cold
Cover and reheat for 2-3 seconds
RECOMMENDED ACCESSORIES & CARE
Apply to:
100% cotton
Poly/cotton blends
100% polyester
Leather
Lycra®/spandex
Recommended Accessories:
Weeder / Tweezer
Transfer Tape (Included)
Laundering:
Wait 24 hours before 1st wash
Machine wash cold / mild detergent
Dry on normal dryer setting
Do not dry clean
Do not bleach
SIZE AND HOW TO APPLY
1) Do not mirror
2) Cut on pattern
3) Weed excess vinyl
4) Apply, peel mask & heat transfer